To Next PageTo Next PageWhat does it mean if my Binder BF 56 Laboratory Equipment chamber is without function, and the standby icon is displayed?
The chamber is likely in standby mode. Press down the standby button until the display lights up.
What to do if there is an electrical hazard during live maintenance work on Binder Accessories?
To avoid electrical hazards during maintenance on your Binder Accessories, ensure the chamber remains dry, never remove the rear panel, and always disconnect the chamber from power by turning off the main switch (for ED, FD, FED size 720 models) and pulling the plug. It is essential that only licensed electricians or experts authorized by BINDER perform any maintenance work.
How to fix a Binder Laboratory Equipment fan that doesn’t turn or turns too slowly?
If you have a BF or FED model, the fan speed might be set too low; set the fan speed to 100%. If the problem persists, further assistance is needed.
What does the alarm message “!TProt” mean on my BD or BF Binder BF 56 Laboratory Equipment?
The safety device class 3.1 has responded. Check the settings of the temperature set-point and of the safety device class 3.1.
Why are there deviations from the indicated heating-up times in my Binder Laboratory Equipment?
The chamber might be fully loaded. Try loading the chamber with fewer items or consider allowing longer heating-up times.
What to do if the Binder BF 56 chamber has no function and the standby icon is displayed?
The chamber is likely in standby mode. Press down the standby button until the display lights up.
Qualification requirements for personnel operating the chamber.
Requirements for chamber setup environment.
Steps and specifications for powering the chamber.
Entering desired operational values.
Function and cut-off points of the primary safety device.
Explanation of Class 2 and Class 3.1 safety controllers.
Configuring the safety controller's limit temperature.
Steps to handle system alerts.
Setup for automatic shutdown after a set time.
Timer starting based on temperature.
Timer delaying operation start.
Methods for sterilizing or disinfecting the chamber.
Basic steps to resolve common chamber errors.
Qualification requirements for personnel operating the chamber.
Requirements for chamber setup environment.
Steps and specifications for powering the chamber.
Entering desired operational values.
Function and cut-off points of the primary safety device.
Explanation of Class 2 and Class 3.1 safety controllers.
Configuring the safety controller's limit temperature.
Steps to handle system alerts.
Setup for automatic shutdown after a set time.
Timer starting based on temperature.
Timer delaying operation start.
Methods for sterilizing or disinfecting the chamber.
Basic steps to resolve common chamber errors.
General| Brand | Binder |
|---|---|
| Model | BF 56 |
| Category | Laboratory Equipment |
| Language | English |
