Binder KB 53 (E4) - Page 27

KB (E4 + E6) 02/2017 page 27/148
Fixed value
08.03.2015 05:05:06
General menu (next page)
(“Optional equipment” menu item is visible only with
optional chamber equipment)
..\ Menu
Measurement chart
Optional equipment
Sensor adjustment
Service contact
System information
Close Home
Controller mode
Switching between the operating modes “control off” or “fixed value”,
chap. 6.2.1
Event list
Display of status information and errors, chap. 15
Alarms
Alarm settings, chap. 14.5
Setpoints
Setpoint entry in “Fixed value” operating mode, chap. 7.5
Safety controller
Setting the safety controller, chap. 17.2 and 17.3
Programs
Time and week programs, chap. 9 and 10
Import/Export
Data transfer via USB interface, chap. 13
Settings
General controller settings, chap. 12
Measurement chart
Graphical display of the measured values, chap. 16
Optional equipment
Setting for optional equipment like interior socket, zero-voltage relay
control outputs, alarm output, object temperature display, chap. 7
(menu item is visible only with optional chamber equipment)
Sensor adjustment
Adjustment menu for single-point and two-point adjustments (for Ser-
vice purpose)
Service contact
Service information
System information
Chamber information (model, name, serial no., firmware etc.)