Binder KB 53 (E4) - Starting Time Programs

KB (E4 + E6) 02/2017 page 42/148
9.1 Starting and running an existing time program
To start a time program, go to Menu > Programs > Time program > Start.
(You can also go to Quick menu > Time program > Start , see below).
Starting is also possible directly from the program editor (chap. 9.3.9).
In the “Control off” mode or during a running time or week program, no time program can be
started.
Fixed value
08.03.2015 05:05:06
Submenu “Time program”.
Select “Start” to start an existing program
and press the operating button.
..\ Programs\Time programs
Start
Stop
Pause
Resume
Edit
Create
Rename
Delete
Close Home
If no program has been created and saved so far, the message “No programs found” appears. Press the
operating button to confirm with “Ok” and enter a program with “Create”.
Fixed value
08.03.2015 05:05:06
Submenu “Select program” (example).
Select one of the programs
and press the operating button to run the program
..\ Select program
Program0001
Program0002
Program0003
Close Home
Fixed value
08.03.2015 05:05:06
Entry menu “Start date”.
The current date is shown. For a postponed start,
enter the desired start date with the operating but-
ton.
Press the “Ok” button to confirm.
..\ Start date (DD.MM.YYYY)
0
8.03.2015
0
Ins Pos1 End Ok 1 2 3 4 5 6 7 8 9
Close Ok Home