Binder KB 53 (E4) - Entering the Set-Points Via General Menu

KB (E4 + E6) 02/2017 page 38/148
8.3 Entering the set-points via general menu
To enter set-points via general menu, go to Menu > Setpoints
Fixed value
08.03.2015 05:05:06
Submenu “Setpoints”.
Select “Temperature” or “Fan speed”
and press the operating button.
..\ Setpoints
Temperature
Fan speed
Close Home
Temperature setting
To enter the temperature setpoint, go to Menu > Setpoints > Temperature
Fixed value
08.03.2015 05:05:06
Entry menu “Temperature setpoint”.
Select each number with the operating button and
press the operating button to confirm.
Setting range: -10 °C / 14 °F up to +100 °C / 212 °F
Press the “Ok” button to confirm.
..\ Temperature setpoint
2
5.0
[°C]
2
Pos1 End Ok 0 1 3 4 5 6 7 8 9 , -
Close Ok Home
When entering a value outside the setting range, the message “Invalid value” appears. Press the operat-
ing button to confirm with “Ok” and repeat the entry with a correct value.
Go back to the initial view with “Home” or enter the fan speed.