USER MANUAL
TD069-O&M-001
REVISION 6
Page 36 of 80
The Operator must be LOGGED ON to run a gassing cycle. Refer to section 5.4.3
for information on managing users of the system.
This page depicts the system
configuration.
Select the cycle button, on
the navigation bar.
The Cycle Start Page is displayed.
Supervisor or above access level
is required to change the type of
cycle, i.e. complete system or
HPV only cycle, after which an
Operator can choose and run a
cycle. After a complete system
cycle it automatically reverts
back to a HPV only cycle.
Select cycle recipe from the list
shown.
Press “Load”.
selection
The cycle name of the currently loaded
cycle is displayed here. Press to view/
select from the list of cycles.
Section 4.4 )
To Next Page
Loading...