USER MANUAL
TD069-O&M-001
REVISION 6
Page 60 of 80
Replace with a new roll of paper
ensuring correct orientation (as
shown).
Push cover closed. The printer is
now ready to use.
6.2 Scheduled Maintenance
For GMP compliance sensor calibration and functional checks may be performed
on a 6-monthly basis, depending on application assessment. Otherwise scheduled
Routine maintenance should be performed on an annual basis with a Major
Service every 4 years.
Only genuine replacement parts supplied by a Bioquell-trained Service Provider
must be used to ensure safe operation.
Servicing of optionally supplied sub-systems, i.e. Sterility Test Pump,
environmental monitoring particle counter ought to be performed by the
equipment supplier during the QUBE scheduled service visit.
The following web link details all the Merck /EMD Millipore offices around the
globe to arrange servicing of the Sterility Test Pump:
http://www.millipore.com/offices/cp3/officeshome
The following web link provides the contact details for Pharmagraph global agents
to arrange servicing of the Particle Monitoring System:
http://www.pharmagraph.co.uk/agents/locations-worldwide/agents/12-13
To Next Page
Loading...