Bioquell QUBE - Cycle Printouts and Load Reports; Cycle Recipes: Viewing and Management

USER MANUAL
TD069-O&M-001
REVISION 6
Page 44 of 80
4.3.6Printouts
4.3.6.1 Cycle Printout (QHPV)
The following information will be included on the cycle printout:
HEADER:
· Time and Date
· Software versions
· Serial Number (of QUBE system)
· Cycle count
· Calibration due date
DECONTAMINATION INFORMATION:
· H
2
O
2
Lot Number
CYCLE INFORMATION:
· Cycle Name
· Cycle parameters
· Current time and phase status (i.e. Conditioning, Gassing, Gassing Dwell,
Aeration and Complete) including parameters (i.e. chamber pressure,
temperature and RH; peak H
2
O
2
.)
· Operator Name
· Signature Box
ALARMS AND WARNINGS:
· Alarm details if cycle failed
4.3.6.2 Product Transfer Printout (QMTD Option)
If part of the configured system, the User can print a load data exit report,
including:
· References from the QUBE plus time and date record
· Aseptic hold status of the processing modules
· Space for entering signature
· Space for manually entering load reference
4.4 Cycle Recipes
There are two sets of recipes: one set for a single QHPV module and one set for
the complete QUBE system.
4.4.1Viewing Recipes
For QHPV only cycles those with Operator or above access level may view the
cycle parameters. For full system cycles those with Supervisor or above access
level may view them.