USER MANUAL
TD069-O&M-001
REVISION 6
Page 9 of 80
epairs or adjustments to the Bioquell
a Bioquell Service Provider or those trained to perform such procedures by
Bioquell. Non-routine maintenance performed by unqualified personnel or
installation of unauthorised parts could cause personal injury or result in
damage.
The equipment must be serviced in accordance with the Maintenance
Schedule to maintain safe performance. Potential hazards or failure of
performance may occur if the equipment is not serviced by trained and
authorised personnel. Contact your Bioquell Service Provider to schedule
preventative maintenance or for emergency repairs.
Use of traditional alcohol
wipes must be avoided to prevent
damage to the sensitive electrical components within the QUBE system
especially the Hydrogen Peroxide sensor.
Use of paper or other abrasive cloths could potentially damage the QUBE
front screen during cleaning.
Do not cover the top of the QMTD as this could potentially block the filter.
DANGER – PERSONAL INJURY HAZARD
module approx. 240Kg (529.1 lbs) and the QMTD module approx. 64 kg
(141 lbs). Local manual handling regulations and SOPs must be adhered to
when moving this equipment to prevent personal injury. Assisted
mechanical devices will be required if moving over a threshold or for any
distance.
Take care when moving the Bioquell
on flat surfaces only. Secure by
support feet to stop the unit moving.
Do not tilt the unit over as toppling may occur.
contains electrical connections. Always disconnect the
power supply before gaining access to electrical and pneumatic systems for
inspection or maintenance. Access to these systems should be restricted to
trained personnel; failure to do so may cause an ELECTRICAL INJURY
HAZARD.
1.3 Warning Labels within the QUBE
ELECTRICAL INJURY
HAZARD
Only trained personnel
should be accessing the
electrical system
To Next Page
Loading...