INTRODUCTION NAVIGATION RADIO MODE CD MODE SETUPCD CHANGER
180
Entering the wrong code number
If you inadvertently entered and confirmed the wrong code, you can enter it
again. To prevent thieves from working out the numerical code by trial and error,
the unit will be locked for one hour if the code is entered incorrectly three times.
The device must remain switched on for one hour before you can try entering
the code again. If the unit is disconnected from the power supply during this
waiting period, the countdown will be reset and the waiting period will be set to
one hour again.
You can also disable the code request feature. For further information, read the
section entitled “Enabling/disabling the device code” in the “Setup - basic set-
tings” chapter.
To Next Page
Loading...
