167
INTRODUCTION NAVIGATION RADIO MODE CD MODE SETUPCD CHANGER
ESPAÑOL
PORTUGUÊS
ENGLISH
Safety information
The TravelPilot has been designed for use in passenger cars.
Special information such as height restrictions or maximum permitted road load, which is required for navigating
trucks and buses, is not included on the navigation CDs.
Operating whilst driving
If you do not pay attention to the road and traffic situation, you could cause serious accidents.
In order to avoid being distracted by the TravelPilot, please observe the following:
• Familiarise yourself with the TravelPilot and how to operate it before setting off on your journey.
• Stop your vehicle at a suitable location if you wish to reprogram the TravelPilot.
• Operate the TravelPilot whilst driving only if the road and traffic situation allows you to do so.
• Only enter a destination whilst the vehicle is stationary.
Inserting / removing a CD
• For safety reasons, you should only insert or remove a CD when the vehicle is stationary.
• Only open the control panel to insert / remove a CD.
• After inserting / removing a CD, close the control panel immediately to ensure that the unit is ready for operation
before setting off on your journey.
To Next Page
Loading...
