Blaupunkt TravelPilot DX-R52 - Entering a Destination - Position Marker

194
INTRODUCTION NAVIGATION RADIO MODE CD MODE SETUPCD CHANGER
To access destinations from the destination memory,
1 press the NAV button 7.
✔ The last destination in the current navigation memory bank is displayed
for seven seconds. After the seven seconds have elapsed or after the
ESC button 8 has been pressed, a menu for selecting the destination
type (CITY or SPECial DESTinatioN) is displayed.
2 Press the NAV button 7 repeatedly until the required memory bank is
displayed.
3 Press one of the 1 - 6 buttons > that corresponds to the stored destina-
tion.
✔ The destination that is stored on the button you selected is displayed.
4 If you want to use the destination for navigation, press the OK button ;.
✔ Navigation begins. For further information, read the section entitled “Nav-
igation”.
Entering a destination - position marker
You can use one of your preset position markers as a destination. A position
marker is the vehicle position that you stored during your journey whilst the
navigation CD was inserted but whilst navigation was inactive. So you can, for
example, set position markers at interesting places that you want to return to at
some other point in time. The navigation CD must be inserted in order to set a
position marker (for further information, read the section entitled “Storing a posi-
tion marker in the destination memory” in this chapter).
Selecting a position marker as your destination
Position markers are accessed in the destination memory in the same way as
other destinations. For further information, read the explanation on “Entering a
destination - from the destination memory”.
NAV
N1NAVI
DESTN 3...
BERLIN, UNT
ER DEN LIN
DEN