Blaupunkt TravelPilot DX-R52 - Starting Navigation; Entering a Destination

182
INTRODUCTION NAVIGATION RADIO MODE CD MODE SETUPCD CHANGER
Note: The process of loading the software from the navigation CD
must not be interrupted.
Starting navigation
1 Press the NAV button 7 whilst the unit is switched on.
✔ The last destination in the current navigation memory bank is displayed
for seven seconds.
Similar to the radio, the navigation system also has several memory banks at its
disposal (N1, N2, N3 and N4). You can store six destinations in each of these
memory banks with buttons 1 - 6 >. When you access a memory bank, the last
destination in the memory bank is displayed. This last destination is not neces-
sarily one which is stored in the memory bank - it is merely the last destination
that was being driven to from this memory bank.
✔ After the seven seconds have elapsed or after the ESC button 8 has
been pressed, a menu for selecting the destination type (CITY or SPECial
DESTinatioN) is displayed.
To switch between the navigation memory banks N1...N4,
1 press the NAV button 7 repeatedly until the required memory bank ap-
pears in the top line of the display.
Before navigation can begin, a TravelPilot DX navigation CD must first be in-
serted and a destination selected.
Entering a destination
The destination can be entered from the destination memory or by entering a
place name, a centre, the road name, intersection or house number, or by se-
lecting a special destination (e.g. a motorway junction, train station, hotel, shop-
ping centre, etc.).
NAV
N1NAVI
LAST DESTN
BERLIN, UNT
ER DEN LIN
DEN
NAV
N1
DESTN TYPE...
SPEC DESTN
CITY
SELECT
/
/
/
/
/
/
NAV
N4NAVI
NO
LAST
DESTN