209
ESPAÑOL
PORTUGUÊS
ENGLISH
INTRODUCTION NAVIGATION RADIO MODE CD MODE SETUPCD CHANGER
Scanning receivable stations (SCAN)
You can briefly play (scan) all the receivable stations. The scanning time is 10
seconds.
Starting SCAN
1 Keep the OK button ; pressed for longer than two seconds.
✔ Scanning begins. SCAN appears briefly in the display followed by the
current station name or frequency.
Stopping SCAN and continuing listening to a station
1 Press the OK button ;.
✔ Scanning is stopped and the station that was tuned into last will remain
active.
Traffic information
Your unit is equipped with an RDS-EON receiver. EON stands for Enhanced
Other Network.
Every time a traffic announcement (TA) is transmitted, you will automatically be
switched from a station that does not provide traffic information to a station with-
in the broadcasting network that does.
Once the traffic information message has been played, you will be switched
back to the programme that you were listening to before.
Note: You can set the volume for traffic announcements. For further
information, read the section entitled “Setting the minimum volume
for traffic announcements - TA VOLUME” in the “Setup - basic set-
tings” chapter.
NAV
FM
T
SCAN
R
D
S
L
D
O3 45
p
m
To Next Page
Loading...
