234
INTRODUCTION NAVIGATION RADIO MODE CD MODE SETUPCD CHANGER
Calibration after a tyre change
It may be necessary to recalibrate the TravelPilot after a tyre change.
1 Select TYRE CHaNGE from the installation menu.
2 Please drive along a route of between 4 and 10 miles with good GPS
reception.
✔ The system carries out the calibration automatically.
Manually calibrating the system
You can also manually calibrate the system. You will be required to drive a route
of at least 350 feet at a maximum speed of 19 mph. Please note that a route
must be used that has been measured as precisely as possible.
1 Select MANual CALIBration from the installation menu.
✔ You will now be asked to enter the length of the route that you want to
drive.
2 Set the route length using the
or button :.
3 Press the OK button ;.
✔ You will be asked to drive the route.
4 Press the OK button ;.
5 Carry out the operating steps as instructed by the system.
NAV
INSTALL
NEW INSTLL
TYRE CHNGE
SYS TEST
MAN. CALIB
NAV
INSTALL
NEW INSTLL
TYRE CHNGE
SYS TEST
MAN. CALIB
To Next Page
Loading...
