212
INTRODUCTION NAVIGATION RADIO MODE CD MODE SETUPCD CHANGER
3 Carefully insert the CD with the printed side uppermost into the unit’s CD
compartment. Push the CD until you feel some resistance. From this
point onwards, the CD will be drawn in automatically.
✔ CD playback begins automatically after the CD has been checked. The
main CD menu appears.
Starting internal CD playback (if no CD changer is connected)
If an audio CD is inserted and no CD changer is connected,
1 press the CD•C button 5.
✔ The unit switches to the main CD menu and CD playback begins. You
will hear a warning beep if no audio CD is inserted.
Starting internal CD playback (if a CD changer is connected)
If a CD is inserted in the internal CD drive and a CD changer is connected, the
unit switches to the main CD menu after you press the CD•C button 5. The CD
source (CD or CD changer) that was last active will be played.
If the last CD that was listened to was played in CD changer mode, the unit
opens the main CD changer menu.
If you want to activate the internal CD drive,
1 press the CD•C button 5 again.
✔ The unit switches to CD mode.
Traffic announcements during CD mode
To switch traffic announcement standby (see the section entitled “Traffic infor-
mation” in the “Radio mode” chapter) on / off whilst in CD mode,
1 press the TRAF button @.
✔ The symbol is shown in the display when traffic announcement standby
is active.
TO2/ 10
O3:24
L
D
To Next Page
Loading...
