Blaupunkt TravelPilot DX-R52 - Switching on a Coded Device after Disconnection from the Battery Power Supply

179
INTRODUCTION NAVIGATION RADIO MODE CD MODE SETUPCD CHANGER
ESPAÑOL
PORTUGUÊS
ENGLISH
Switching on a coded device after
disconnection from the battery power supply
If you switch on a coded unit after having disconnected it from the battery power
supply (for instance, after having carried out a repair to the vehicle), a message
will appear requesting that you enter the code. You will find the numerical code
printed on your device’s equipment pass. Never store the equipment pass in the
vehicle!
To enter the numerical code, proceed as follows:
1 For the first digit of the numerical code: press button 1 > repeatedly
until the first digit of the code appears in the display.
2 For the second digit of the numerical code: press button 2 > repeatedly
until the second digit of the code appears in the display.
3 For the third digit of the numerical code: press button 3 > repeatedly
until the third digit of the code appears in the display.
4 For the fourth digit of the numerical code: press button 4 > repeatedly
until the fourth digit of the code appears in the display.
Once you have finished entering the whole numerical code,
5 keep the OK button ; pressed for longer than two seconds.
✔ The device switches on.
The clock time must be entered manually if the power supply was cut.
6 Set the hours by pressing the
or button :.
7 Press the button :.
✔ The minutes flash.
8 Set the minutes by pressing the
or button :.
9 Press the OK button ;.
NAV
1OOO
NAV
TIME ——
·
——
R
D
S
L
D