Blaupunkt TravelPilot DX-R52 - Enabling;Disabling the Device Code

231
ESPAÑOL
PORTUGUÊS
ENGLISH
INTRODUCTION NAVIGATION RADIO MODE CD MODE SETUPCD CHANGER
Note: Navigation voice output depends on the navigation CD being
used. The display content will be displayed in the selected language
but the voice output might only be available in English.
To switch between the languages,
1 press the MENU button 1.
2 Keep pressing the
or button : until LANGUAGE appears in the dis-
play.
3 Keep pressing the
or button : until the required language appears
in the display.
4 When you have finished making your changes, press the MENU button
1 or OK ;. If you do not want to apply the changes, press the ESC
button 8.
Enabling/disabling the device code
If you switch on a code-enabled unit after it was disconnected from the vehicle’s
power supply, you will have to enter the device code. You can also disable this
code request feature.
1 Press the MENU button 1.
2 Keep pressing the or button : until CODE appears in the display.
The current setting is displayed alongside CODE. OFF means that the
code feature is deactivated, ON means it is activated.
3 Press the
or button : to change the setting.
4 Enter the code as described in the section entitled “Switching on a coded
device after disconnection from the battery power supply”.
5 When you have finished making your changes, press the MENU button
1 or OK ; .
NAV
CODE ON
R
D
S
L
D
O3 45
p
m
NAV
LANGUAGE
R
D
S
L
D
O3 45
p
m
NAV
> ENGLISH IMP
R
D
S
L
D
O3 45
p
m