228
INTRODUCTION NAVIGATION RADIO MODE CD MODE SETUPCD CHANGER
Setting seek tuning sensitivity
You can choose whether the system should only tune into stations with a strong
reception or whether it can also tune into those with a weak reception.
1 Press the MENU button 1.
2 Keep pressing the or button : until SEEK SENS appears in the
display.
3 If you only want to receive interference-free stations select SENS ON. If
you want the radio to also be able to receive stations with strong interfer-
ence select SENS OFF. To do so, press the
or button :.
4 When you have finished making your changes, press the MENU button
1 or OK ;. If you do not want to apply the changes, press the ESC
button 8.
Setting the system time
The clock is set using the GPS signal. You must set the difference in time be-
tween your local time and Universal Time/GMT. The system automatically asks
the user to enter the time when the device is started for the first time or if the
power supply was interrupted. You can also set the time in the setup menu.
Note: The minutes can only be set if the device has not yet received
a GPS signal.
1 Press the MENU button 1.
2 Keep pressing the
or button : until CLOCKSET appears in the dis-
play.
3 Press the or button :.
✔ The time appears in the display, and the hours flash.
4 Set the hours by pressing the or button :.
5 Press the
button :.
NAV
SEEK SENS
R
D
S
L
D
O3 45
p
m
NAV
CLOCKSET
R
D
S
L
D
O3 45
p
m
NAV
TIME O3
·
45 PM
R
D
S
L
D
O3 45
p
m
To Next Page
Loading...
