Blaupunkt TravelPilot DX-R52 - Defining Route Options

200
INTRODUCTION NAVIGATION RADIO MODE CD MODE SETUPCD CHANGER
Defining route options
You can customise the route to suit your requirements at any time, even during
an active navigation session.
The configurable parameters are:
– ROUTE: Choose between the quickest or shortest route or dynamic nav-
igation with TMC.
– MOTORWAY: You can specify whether you want to use motorways during
your navigation session.
– FERRY: You have the option of allowing the system to use ferries or avoid
them.
– TOLL ROADS: You have the option of excluding or including roads, for
which toll charges are levied, from your navigation sessions.
Note: If, for instance, you deactivated the motorway option and a
very long detour would be the result of applying this option, the
TravelPilot will instead decide to include motorways in its route cal-
culations. The same applies to ferries and toll roads.
To define the route options,
1 keep the NAV button 7 pressed for longer than two seconds.
✔ The route options menu is displayed.
2 Use the
or button : to select the menu item that you want to change
(route, motorway, ferry or toll roads).
Note: If you select dynamic navigation you cannot change the
MOTORWAY, FERRY and TOLL ROADS menu items!
3 Select the required setting using the or button :. Motorways, ferries
and toll roads will be used if a tick mark is displayed alongside the corre-
sponding menu item.
NAV
T
M
C
ROUTE OPTIONS
ROUTE
DYNAMIC
ROUTE OPT
/
/
/
/
/
/
NAV
T
M
C
ROUTE OPTIONS
MOTORWAY
ROUTE OPT
/
/
/
/
/
/
NAV
T
M
C
ROUTE OPTIONS
FERRY
ROUTE OPT
/
/
/
/
/
/
NAV
T
M
C
ROUTE OPTIONS
TOLL ROADS
ROUTE OPT
/
/
/
/
/
/
1