202
INTRODUCTION NAVIGATION RADIO MODE CD MODE SETUPCD CHANGER
NAV
N1NAVI
NEW DESTN...
BERLIN,
UNT
ER DEN LIN
DEN
Destination memory
In the destination memory you can store destinations that you want to navigate
to at some other point in time. You can also set your current position as a posi-
tion marker and then access it from memory at some other point in time to use it
as your destination. It is not possible to set a position marker during an active
navigation session.
There is space for storing a total of 24 destinations - six in each of the navigation
system’s memory banks N1...N4.
Storing a new or the last destination in the destination memory
After you have finished entering the destination and before starting navigation,
you have the option of storing the destination in the destination memory.
1 Press one of the 1 - 6 buttons > for longer than two seconds to store the
destination to that button.
✔ You will hear a confirmation beep when the destination has been stored.
If you want to store a memory bank’s last destination,
1 press the NAV button 7 repeatedly until the required memory bank con-
taining the last destination appears in the display.
2 Whilst the destination is being displayed, press one of the 1 - 6 buttons
> for longer than two seconds to store the destination to that button.
✔ You will hear a confirmation beep when the destination has been stored.
To Next Page
Loading...
