13
Bezpečnostní pokyny
Sicherheitshinweise
Safety notes
5. For swallowing, drink a lot of water and induce vomiting. Look for medical help.
1.6.2. Safety information for the chip remover
If the machine is switched on, operate it only using the control panel (see Chapter 3
Machine control).
1.7. Umístění štítku stroje /
Maschinenschild position /
Position of machine label
The machine label is located on the saw frame, between pillar and band drive.
The chip remover is auxiliary equipment, following information
applies only for equipment with this conveyor.
Attention!
It is forbidden to enter the swarf conveyor area if the saw is in operation.
All maintenance and other works on the swarf conveyor could be done
only on equipment which has been switched off.
To Next Page
Loading...
Need help?
General
