58
Manual version: 1.10 / Jan. 2011
Manual rev.: 1
Údržba stroje
Wartung /
Machine smaintenance
4.7. Worn pieces replacement
4.7.1. Pushing bearing replacement
If it is impossible to adjust the bundle gripping assembly and the pushing bearing is
worn, it needs to be replaced.
The bearing condition is possible discover, on the cube from the bottom side, for a
better inspection is possible to put out the holder of the bearing from the cube.
If the bearing is worn, there is a visible channel on it.
Bearing replacement:
1. Dismantle the saw band.
2. Release 2 Screws from hardmetal plate.
3. Release fixing screw with IMBUS (see arrow).
To Next Page
Loading...
Need help?
General
