Bomar Individual Automatic Series User Manual

53
Údržba stroje
Wartung
Machine maintenanceseZávady
4.3.3. Saw band run setting
Saw band run is set with screw (arrow) in the stretching cube on the saw arm. Right
distance rear part of the saw band from wheel rim is 1 – 3 mm.
• Turn with the screw to the right, the saw band is closer to the stretching wheel
rim.
• Turn with the screw to the left, the saw band is far from the stretching wheel rim
Check saw band run adjustment again.
4.3.4. Adjusting of the limit switch of the saw band stretching
After the saw band is replaced, the saw band stretching must be checked. If the limit
switch is not adjusted correctly, the band is stretched too little or too much.
• Tighten the saw band by means of the TENZOMAT on the optimal value (table is
on the Tenzomat).
• If the drive engine is switched on, but it is not running, turn with the screw
clockwise, until the engine begins run..
• If the drive engine is possible switched on, turn with the screw anticlockwise, until
the engine is stopped and then turn with the screw clockwise, until the engine
begins run.

Bomar Individual Automatic Series Specifications

General

Brand	Bomar
Model	Individual Automatic Series
Category	Saw
Language	English