Bomar Individual Automatic Series - Cutting Procedure in One Cut Automatic Mode

37
Ovládání stroje Bedienung der Maschine Machine control
Option Description
Use the chip remover during cutting – YES/NO.
3.4.1. Cutting procedure in One cut automatic mode
Cutting progress in “One cut automatic mode”:
1.
Prepare the cutting material, load it to the saw and clamp into vice
2.
Set the One cut automatic mode, see previous text – Preparation before cutting.
3.
Press START button to start.
4.
The following menu appears on LCD, the frame starts to descend into the cut – the
semiautomatic cycle starts.
5.
End the One cut automatic mode by turning the key switch into other position.
Window showing progress of the semiautomatic cycle:
Item Description
Saw band speed set by frequency
changer – control panel, position 7
Total time of the One cut automatic
mode duration.
Number of pieces cut in the One cut
automatic mode.
Individual parameters set in menu
Preparation before cut.