40
Manual version: 1.10 / Jan. 2011
Manual rev.: 1
Ovládání stroje
Bedienung der Maschine
Machine control
Button Description
Switch off the saw band drive after cut –
Switch off the band / do not switch off the band.
Switch off the cooling pump after cut –
Switch off the pump / do not switch off the pump.
Cooling method during cutting:
• Cooling liquid
• Micronization (optional accessory)
• No cooling
Use the chip remover during cutting – YES/NO.
Enter the cutting parameters
Parameters:
• Program no. – number of the start program
• Set number – loads the numbed of pieces from
program(s)
• Finished cut – number of pieces cut before the last
interruption of the program
• Remains to be cut – number of pieces remaining to be
cut
• Cut length – length of one piece
• Number of pieces – already cut
If the measurement frame (for detection of clamped material for cutting) is not
installed, the operator is before the start of the automatic mode requested to set the
saw frame into its highest position to the upper limit switch.
To Next Page
Loading...
Need help?
General
