104 en | DMS - Data Management System BIS 2.3 - Access Engine
F.01U.028.713 | V 2.3.0.1 | 2009.11 Installation manual Bosch Sicherheitssysteme GmbH
10.2.9 Time Attendant Account Exchange (TAccEXC)
When using the door model 06, where only two readers are
configured for the recording of booking times, the TAccEXC
sends the collected bookings to these readers at predefined
times and forwards them to an external time management
system.
10.3 Batch processes
10.3.1 Overview
Under the name midnight processes or batch processes, all
processes are combined that are not necessary for the system
flow and thus do not need to be active constantly. They are
started around midnight. These functions primarily consist of
updating and “housekeeping” tasks for the database.
The start time was selected as the date change takes place at
00:00:00. The date change is important, for example, if an
identification card is only to be valid as of a particular day.
When the date change takes place at midnight, therefore, a
process is started that releases all identification cards that are
to be valid as of this date and that locks all identification cards
that were valid until the previous day.
Like all DMS processes, the batch processes are also controlled
by the master. For this there is also one entry apiece in the file
PrcTable.tbl:
define LOP
set /executable=lop-d.exe
set /ready=0
set /parameter="/O=(Term,File,Logsrv) /t=2"
set /restartlimit=3
set /type=batch
set /errorReset=100
set /exitNumber=1500
set /batchStart=00:02.00
set /batchPeriod=daily
add
To Next Page
Loading...
