BIS 2.3 - Access Engine DMS - Data Management System | en 93
Bosch Sicherheitssysteme GmbH Installation manual F.01U.028.713 | V 2.3.0.1 | 2009.11
10.2.3 ACSP - process for access control
The various functional areas are connected to the DMS as self-
sufficient subsystems via interface processes.
The interface processes comprise various interfaces:
– The DMS interface to the loggifier, via which data changes
are recognized (which then cause data change orders on
the subsystem) and events reported by the subsystem are
entered into the event logs.
– A client interface via which control orders from the DMS to
the subsystem can be transmitted.
– The interface to the subsystem via which both control and
data change orders to the subsystems and also status and
event messages from the subsystem are exchanged.
The status of the subsystem is also monitored via this interface.
Functions
The actual access control system is controlled by the MAC
(Main Access Controller). It receives all necessary data from the
DMS from a dedicated interface process.
To Next Page
Loading...
