Bosch BIS 2.3 - Hardware Connections and Configuration; Connecting Controllers

BIS 2.3 - Access Engine Connecting the controllers | en 65
Bosch Sicherheitssysteme GmbH Installation manual F.01U.028.713 | V 2.3.0.1 | 2009.11
7 Connecting the controllers
This chapter describes the connection variants for controllers.
With distributed systems (see Section 3.2 Distributed system),
the controller is connected to the remote or connection server.
7.1 General
The AMC2 4W controller will be connected to the host system
via Ethernet, only.