Bosch BIS 2.3 - System Configuration Procedures; Start Configuration Browser

24 en | System configuration BIS 2.3 - Access Engine
F.01U.028.713 | V 2.3.0.1 | 2009.11 Installation manual Bosch Sicherheitssysteme GmbH
4 System configuration
The installed BIS software and its integrated engines cannot be
used until the system has been configured. Configuration
means adapting the system to a particular client’s environment
individual requirements.
It is possible create multiple different configurations,
nevertheless only one can be activated, i.e. loaded, at any one
time.
4.1 Starting the Configuration Browser
To create a system configuration or to modify an existing one,
you must first start the Configuration Browser.
To start the Browser proceed as follows:
1. If the BIS Manager has not yet been started:
– Start the BIS Manager by double-clicking the desktop
icon.
– Log in with your username and password.
2. On the System start/stop tab, click the Start button to the
left-hand side of the Configuration Browser label
3. A new window is opened for creating and reopening
configurations. Select the configuration you require in the
Recent configuration field by clicking the corresponding
entry.
1. Another login dialog appears; log in with an Administrator
username and password.
i
NOTICE!
In the case of Access Engine, the configuration selected in the
Configuration Browser must also be loaded so that the specific
applications can be called.
i
NOTICE!
To create a new configuration, first carry out the steps
described in Section 4.2 Setting up a configuration, Page 25.