Bosch BIS 2.3 - Setting up Video Verification; Set Up Video Verification

BIS 2.3 - Access Engine Setting up Video Verification | en 121
Bosch Sicherheitssysteme GmbH Installation manual F.01U.028.713 | V 2.3.0.1 | 2009.11
12 Setting up Video Verification
Setting up Video Verification
BIS can be configured so as to display a cctv image of the
relevant area whenever someone checks in at a particular
reader.
At the same time an archive photo of the person checking in can
be displayed for comparison.
Based on this visual verification the operator can decide
whether or not to admit the person.
In order to set up this functionality please proceed as follows:
1. Open a Windows Explorer on <InstallationDisk>:
\MgtS\Customer_Configuration\<Name of
Configuration>\Documents\Actionplans.
– Select the file VideoVerificationACE.htm.
– Open the file in a text editor: (right click) > Open
with... > <Editor>.
Note: if you double click the file this will normally
start the Internet Explorer. An editor (normally Note-
pad) may be invoked from here by clicking View >
Source
– Find the lines containing LiveImageUrl.
i
NOTICE!
Necessary extra equipment is a camera which is able to view
the relevant area.