Bosch BIS 2.3 - Page 122

122 en | Setting up Video Verification BIS 2.3 - Access Engine
F.01U.028.713 | V 2.3.0.1 | 2009.11 Installation manual Bosch Sicherheitssysteme GmbH
– Depending on the type of camera you wish to use,
uncomment the appropriate line by removing the
slashes // at the beginning of it, and change the IP-
Address in the file to that of the camera you wish to
use.
– Save and close the file.
2. Start the BIS Configuration Browser and click the menu
Connections.
– Select the entry reader for the relevant entrance in
the device explorer.
– Select the tab Door Control and check the box
labeled Host Verification.
i
NOTICE!
Only one LiveImageUrl URL may be active (uncommented) at
one time. Please make sure that the other is commented out or
deleted.