32 en | System configuration BIS 2.3 - Access Engine
F.01U.028.713 | V 2.3.0.1 | 2009.11 Installation manual Bosch Sicherheitssysteme GmbH
4.6.2 PIN Code Settings
These configuration settings refer to
the permitted number of mistyped attempts.
the minimum length of the PIN
4.6.3 Card encoding
The reader parameter Check membership only values can be
set in the device editor. If set then only the company data on
the badge are checked against the stored values. Up to four
different company codes can be stored.
This setting allows employees from different branch offices
access at the specified readers’ entrances, even if their
personal card data are not stored locally.
4.6.4 Card readers at Access Engine workstations
Each workstation is configured to allow searches for or capture
of personnel data based on the manual entry of a card number.
These workstations can also be equipped with card readers
which allow faster data capture and entry. Card readers with a
serial or USB interfaces are suitable for the purpose. For USB
readers virtual COM ports need to be configured.
To Next Page
Loading...
