BIS 2.3 - Access Engine System configuration | en 29
Bosch Sicherheitssysteme GmbH Installation manual F.01U.028.713 | V 2.3.0.1 | 2009.11
4. Switch to the Connections menu and select the Access
Engine placeholder entry in the Explorer.
– Remove the Access Engine placeholder entry using
the x button or the Remove command in the context
menu (right-click on Access Engine).
– Answer Yes to the confirmation prompt following the
deletion.
– Next select the server entry and click the + button or
select the Add subsystem command in the context
menu.
– Select the Access Engine entry from the list in the
Select new subsystem dialog and confirm the
selection with OK.
5. The synchronization messages and the completion
message appear (see step 9 and 10 in
Section 4.2.1 Creating an initial configuration, Page 25)
The Access Engine applications and dialogs can now be used.
4.3 Loading a configuration
Only one of the configurations you have created can run in the
BIS be loaded at a time. To swap/exchange configurations
proceed as follows:
1. If the BIS Manager has not yet been started:
– Start the BIS Manager by double-clicking the desktop
icon.
– Log in with your username and password.
To Next Page
Loading...
