Bosch BIS 2.3 - Printing Badges

BIS 2.3 - Access Engine Setting up additional workstations | en 43
Bosch Sicherheitssysteme GmbH Installation manual F.01U.028.713 | V 2.3.0.1 | 2009.11
Release Card). This process copies the layouts to the
directory
<InstallDrive>:\MgtS\AccessEngine\CP\Layouts
5.2.4 Printing Badges
In order to print a badge please proceed as follows:
1. Open Access Engine > Personnel Data > Print Badges
2. Select the personnel data for which the badge should be
printed.
3. Select the required layout from the combo-box Layout.
4. If no picture is yet available for this person, but required
for the badge, then you can photograph, imnport or scan a
picture at this point. Please refer to the ACE Card
Personalization program’s own online help if further
assistance is required.
5. Click the button Print.
– Check the correctness of the data in the preview
before printing.
All options belonging to badges, like picture import or scanning,
selecting layouts, and so on, can only be done with a running
card personalization program. Therefore it is installed as an
automatically starting tool.
Console Window
After logon a console window is displayed for a short duration
during the starting process. If the card personalization program
i
NOTICE!
The strict separation between saving a layout and releasing it
for general use enables you safely to store half-finished or
prototype layouts for later editing, without fear that they will
inadvertently be used.
i
NOTICE!
If the preview is not satisfactory please close the dialog.