Bosch BIS 2.3 - Setting up the Configuration Browser

34 en | Setting up additional workstations BIS 2.3 - Access Engine
F.01U.028.713 | V 2.3.0.1 | 2009.11 Installation manual Bosch Sicherheitssysteme GmbH
Figure 5.1 System overview with additional workstations
If you wish to install this workstation for special tasks (e.g. card
personalization), please see the instructions in
Section 5.2 Setting up Card Personalization.
5.1.2 Setting up the Configuration Browser
For the Access Engine dialogs to be executed on a workstation,
they must be entered specially in the Configuration Browser.
1. To do this, start the Configuration Browser as described in
Section 4.1 Starting the Configuration Browser, Page 24.