28 en | System configuration BIS 2.3 - Access Engine
F.01U.028.713 | V 2.3.0.1 | 2009.11 Installation manual Bosch Sicherheitssysteme GmbH
Figure 4.1 Error message when the configuration is not loaded
1. Confirm both this message and the message that follows
regarding the creation of placeholders with OK. A
placeholder is a dummy configuration which supports
connections but can not be edited. We will replace it in the
following steps.
Figure 4.2 Message regarding the use of placeholders
1. Close the Configuration Browser.
2. Switch the current configurations as described in
Section 4.3 Loading a configuration, Page 29 - however,
respond with No when asked whether to start the system
(i.e. the BIS Server component).
3. Now restart the Configuration Browser on the System
start/stop tab.
–In the blue configuration selection window click open
current configuration to open it for editing.
– Log on to the Configuration Browser.
– Check the entries on the License and Server
structure dialog pages as described in steps 11 and
12 in Section 4.2.1 Creating an initial configuration,
Page 25.
To Next Page
Loading...
