68 en | Connecting the controllers BIS 2.3 - Access Engine
F.01U.028.713 | V 2.3.0.1 | 2009.11 Installation manual Bosch Sicherheitssysteme GmbH
1. In the device data editor (Configuration Browser >
Connections > Access Engine) select the respective AMC in
the explorer (left).
– Open the context menu (right mouse button) and
select the New Object entry.
– Another selection list opens. In this list select the New
Extension Board entry.
– There now appears a dialog for selecting the required
extension board .
Using the Type column, you can choose between 8
and
16 I/O boards. Up to three of these extensions can be
connected to one AMC. A combination of 8 and 16 I/O
boards is possible.
NOTICE!
The addresses of the extension boards (1 to 3) are allocated
based on the order in which you created them. When creating
the boards, remember that the addresses may need to be
aligned with the addresses set in the hardware (cf. Hardware
installation of the extension boards).
To Next Page
Loading...
