1 691 606 210 2015-07-29| Robert Bosch GmbH
42 | BSA 43xx | Symbols useden
3.3.4 Switching between the two halves of the
window
The main window is divided into two areas: Main menu
(left) and tester selection zone (right).
It is possible to switch back and forth between the two
halves of the window as follows:
¶ With the keypad:
Press the Tab key.
¶ With the remote control unit:
Press the buttons 2
nd
+ Enter.
+
i If the measurement visualization function is operated
with the mouse, it is not necessary to switch
between the different areas. Each control element
can be accessed directly on the screen with the
mouse.
3.3.5 Selection and actuation of control element
A control element in the main window can be selected
and actuated in the following ways:
¶ With the mouse:
Click onto the control element required.
¶ With the keypad:
Select the control element required with the cursor
keys and then press the Enter key.
or , then
¶ With the remote control unit:
Select the control element required with the
Automatic button or the STOP button and then
press Enter.
or , then
3.3.6 Main menu
The following buttons are provided in the main menu:
Button Action
Opens the task manager.
Opens the "BNetConfig"
configuration program.
Ends measurement
visualization.
¶ Use the mouse, the keypad or the remote control
unit to select and press a button (refer to
Section 3.3.4).
3.3.7 Tester selection zone
In this zone it is possible to select a tester and start
measurements. The following testers are available:
Icon Tester Vehicles Mo-
tor-
cycle
Brake dy-
namome-
ter BSA 43xx /
BSA 44xx
x
Brake dy-
namome-
ter BSA 43xx /
BSA 44xx
x
Suspen-
sion tester
SDL 43x
x
Noise simula-
tor SDL 435
x
Side slip tes-
ter SDL 410
x
The tester currently selected is highlighted by a red
border.
i The "test lane" is made up of all the available testers.
Each tester is implemented in succession.
¶ Use the mouse, the keypad or the remote control unit
to select a tester and start measurement.
To Next Page
Loading...
