1 691 606 210 2015-07-29| Robert Bosch GmbH
50 | BSA 43xx | Manual mode (normal operation)en
5.2.2 Motorcycle test routine
! Heed the Motorcycle test procedure safety instructions given in the "User information" manual 1 691 696 900.
Risk of motorcycle tipping over due to lateral
drifting of the front wheel.
! Use the motorcycle cover on the left side of the rollers. Use the standard cover (clipped in or hinged) on the
right side of the rollers.
i The motorcycle test procedure can only be implemented in manual mode.
i The weight is required for calculation of the braking factor. The weight can be entered or measured as follows:
$ Manual entry by way of remote control.
Manual weight entries have precedence over measured weight values.
$ Axle load weigher in brake tester (special accessory).
Use is automatically made of the measured weight if the weight has not been entered manually.
Step Remote control Result / Display
1. Check prerequisites:
R No motorcycle on brake tester
R Test routine selected.
Left: "Brake tester" device symbol.
Right: Drive-on prompt.
2. Drive onto the brake tester with
the wheel to be measured first and
keeping the motorcycle straight.
Disengage gear. Release brake pedal.
! If the motorcycle is not straight on
the set of rollers, it will slide off
to the side. Counter-steer until the
motorcycle returns to straight position
on the set of rollers. Measurement is
not to be started before this has been
done.
i It may be necessary to drive off the
set of rollers and then drive the
motorcycle back on.
Wheel to be measured is positioned on set of
rollers.
If axle load weigher is being used (special accessory):
The wheel load in kilogrammes appears on the
screen.
To Next Page
Loading...
