Bosch BSA 43 Series - Side Slip Tester SDL 410

1 691 606 210 2015-07-29| Robert Bosch GmbH
64 | BSA 43xx | Automatic modeen
Step Result / Display
 Peak value display (approx. 5 seconds):
$ Road surface adhesion on left and right side (↓).
$ Difference in road surface adhesion (Δ)
$ Resonant frequency on left and right side (f)
$ Difference in resonant frequency (Δf)
4. Drive vehicle out of suspension tester. "Chassis measurement is over.
6.2.3 Side slip tester SDL 410
Step Result / Display
1. Check prerequisites:
R No vehicle on dynamometer!
R Tester/test routine selected.
R "Automatic" mode selected.
 Left: "Side slip tester" device symbol.
 Right: Drive-on prompt.
 Ready for toe measurement.
2. Keeping the vehicle straight, drive both axles at
a constant speed over the side slip tester. Speed
max. 15 km/h.
 Front axle toe is measured.
 Peak value display (approx. 5 seconds):
 Toe misalignment (<-->).
"Toe measurement is over.