Bosch BSA 43 Series - Automatic Mode; Mode Activation and Deactivation; Brake Dynamometer BSA 43 xx; BSA 44 xx

1 691 606 210 2015-07-29| Robert Bosch GmbH
60 | BSA 43xx | Automatic modeen
6. Automatic mode
i Automatic mode is recommended for rapid
performance of one or more measurements not
requiring verification of the measured data.
Principal features:
R Test sequence can be selected by user.
R Automatic starting of measurements.
R No storage of measurement results.
R No print-out of measurement results.
6.1 Mode activation and deactivation
Step Remote control unit Result / Display
¶ Acitvate automatic mode.
Press Automatic
 Mode indicator:
"Automatic" symbol
¶ Deactivate automatic mode.
Press STOP
 Mode indicator:
"Manual mode" symbol
6.2 Test sequences
6.2.1 Brake dynamometer BSA 43xx / BSA 44xx
Step Result / Display
1. Check prerequisites:
R No vehicle on dynamometer!
R Tester/test routine selected.
R "Automatic" mode selected.
 Left: "Brake dynamometer" device symbol.
 Right: Drive-on prompt.