Bosch Rexroth IndraMotion MTX micro - Page 100

created. Spindle index 1 is assigned to the spindle having the lowest system
axis index, spindle index 2 to the spindle with the next higher system axis in‐
dex.
Example:
A system has 4 system axes Dr[1] X; Dr[2] Z, Dr[3] C1, Dr[4] C2. The X and Z
axes are linear axes. C1 is a spindle C-axis. C2 is a spindle.
System axis Type
Phys.
Name
SCSP Ax Sp
Dr[1] AxFunc X SCSP[1] Ax[1] -
Dr[2] AxFunc Z SCSP[2] Ax[2] -
Dr[3]
AxFunc/
SpFunc
C1 SCSP[3] Ax[3] Sp[1]
Dr[4] SpFunc C2 SCSP[4] - Sp[2]
Tab. 8-5: Relation between axis index and spindle index
The table shows the relation for the example, with spindle index Sp[1] being
automatically assigned to the system axis Dr[3] and index Sp[2] to Dr[4].
Parameterizing spindle functions
First parameterize the spindle functions for each spindle in the SP data
group.
Fig. 8-14: Basic spindle function settings
Set the following parameters:
1. NofGears – number of the gear stages required (1 without gear)
2. Specify the following parameters for each required gear stage:
● MaxSpSpeed – maximum speed
Bosch Rexroth AG DOK-MTXMIC-EASY*******-CO06-EN-P98/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
NC parameterization