Bosch Rexroth IndraMotion MTX micro - Results

Please note the information messages.
Calculation and display
If everything has been enabled correctly, start the measurement. The axes
are moved. By pressing the <Start optimization> key, the measurement is
started.
9.5.4 Results
Optimized values
Fig. 9-32: Execute the calculation and display result
Result: Optimized drive values for the previously selected areas. By pressing
the <Complete> key, the values are applied to the drive.
Exit the easy startup mode, either directly by pressing the <Com‐
plete> button or in the Project Navigator by calling the "Easy start‐
up mode" dialog.
Oscilloscope
In the oscilloscope, view the optimization (here: optimization of the frequency
response):
DOK-MTXMIC-EASY*******-CO06-EN-P Bosch Rexroth AG 127/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
Commissioning the drives