6 Software installation and basic projects
6.1 Installing IndraWorks Engineering
6.1.1 Prerequisites
Hardware requirements
The following hardware requirements must be met for installation of
IndraWorks Engineering on the PC:
● IBM-compatible PC, min. requirement: Pentium IV
● CPU clock rate 2 GHz
● RAM: 1GB
● 5 GB free disk capacity on C: drive (incl. temporary memory during in‐
stallation)
●
Graphics resolution at least:
– 800x600 pixels
– Color depth: 16 bits
● DVD drive for installation
● Ethernet interface
IndraWorks Engineering is intended for a screen resolution of 96
DPI (default setting). If other settings are used, this classifies as
unintended use and can result in an incomplete or incorrect dis‐
play of the screen elements.
Recommended requirements
● IBM-compatible PC, i5 quad core
● RAM: 4 GB for 64 bit operating systems
●
Graphics resolution
– 1024x768 pixels
– Color depth: 24 bits
Software requirements
The following operating systems are supported:
● Microsoft Windows 7 (32 bit or 64 bit)
● Microsoft Windows 8.1
Bosch Rexroth equipped and pre-installed industrial PCs are
equipped with Windows 7. These PCs contain a service pack re‐
leased by Bosch Rexroth for the respective operating system at
the time of delivery of . The user is responsible for installing sub‐
sequent service packs or Windows 7 updates.
6.1.2 Installing the software
The figure below shows how to install the software step by step:
1. Insert the DVD. The installation wizard should be started automatically.
Otherwise, double-click on "setup.exe" file to start the installation wizard
2. Please select an installation language (English is default language)
DOK-MTXMIC-EASY*******-CO06-EN-P Bosch Rexroth AG 59/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
Software installation and basic projects
To Next Page
Loading...
