Bosch Rexroth IndraMotion MTX micro - Prepare

Please note that the NC control does not influence the drive dur‐
ing the drive optimization. The drive uses the limit values speci‐
fied by the user.
9.5.2 Prepare
Basic settings
Fig. 9-26: Start "Automatic setting of the axis control"
In the Project Explorer, select the axis to be optimized. Open the entry "Opti‐
mization/Commissioning" under the axis node. Subsequently, start the "Auto‐
matic setting of the axis control".
Determining and optimizing
Fig. 9-27: Selecting the optimization method
DOK-MTXMIC-EASY*******-CO06-EN-P Bosch Rexroth AG 123/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
Commissioning the drives