Possibilities to optimize the axes:
● Optimizing with axis motion
The axes are moved. The optimal axis values are calculated from these
motions.
Please note that the axis might have to be optimized under load.
● Optimization without axis motion
The parameters are calculated. An axis motion does not take place.
Fig. 9-28: Determining and optimizing with axis motion
We describe the path with axis motions. In the next screen, enter the travers‐
ing range for which the axis is to be optimized.
Bosch Rexroth AG DOK-MTXMIC-EASY*******-CO06-EN-P124/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
Commissioning the drives
To Next Page
Loading...
