8.2.2 Basic layout
When opening the "NC configuration" for the first time, the basic NC Configu‐
ration (MAIN) is displayed in the basic layout. Otherwise, the last setting is
displayed.
1: Project Explorer
2: Parameter groups
3: Working area/parameter editor
4: Quick editor
Fig. 8-2: Basic screen "NC configuration"
If you wish to restore the basic NC configuration layout, proceed as follows:
1. Window
2. Reset Windows Layout
3. View
4. Selection window
Fig. 8-3: Restoring the basic setting of the IndraWorks layout for parameteriz‐
ing the NC
Bosch Rexroth AG DOK-MTXMIC-EASY*******-CO06-EN-P88/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
NC parameterization
To Next Page
Loading...
