The error messages are entered in a logbook which can be opened with
<F4>.
10.2.5 Editing parameters
All CNC and drive parameters can be edited using the HMI software.
Fig. 10-15: CNC parameter editor
Editing CNC parameters
Proceed as follows to edit a CNC parameter:
1. Log in as user OEM or Developer user
2. Switch to the <System> operating area
3. ● From Version 12:
Press <F2> (Para.)
Press <F5> (MachPara)
● Version 10:
Press <F2> (Para.)
4. Select the parameter type (e.g., AX for axis parameter) using the ma‐
chine keys
5. Select the desired parameter using the cursor keys
6. Press <Enter> to switch to edit mode
7. Restart the system after having made your changes
DOK-MTXMIC-EASY*******-CO06-EN-P Bosch Rexroth AG 143/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
Operating the IndraMotion MTX micro
To Next Page
Loading...
