Bosch Rexroth IndraMotion MTX micro - Parameter Groups; Quick Editor

8.2.3 Parameter groups
The NC parameters are divided in two main groups:
● Configuration parameters
● Basic parameters
Fig. 8-4: Parameter groups
8.2.4 Quick editor
Use the window for parameter instances to optimize the overview and the ed‐
iting process.
Proceed as follows:
1. Select "Physical Drive Name". The selected line is highlighted with bor‐
ders and blue coloring.
2. All drives for this parameter are listed in the bottom area. The selected
parameter can be edited for all axes in this window.
DOK-MTXMIC-EASY*******-CO06-EN-P Bosch Rexroth AG 89/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
NC parameterization