Bosch Rexroth IndraMotion MTX micro - Default Chapter; Table of Contents

Table of Contents
Page
1 About this documentation.............................................................................................. 5
1.1 Validity of the documentation.................................................................................................................. 5
1.2 General information................................................................................................................................ 5
1.3 Required and supplementing documentation MTX micro....................................................................... 7
1.3.1 Selection/compilation........................................................................................................................... 7
1.3.2 Configuration....................................................................................................................................... 7
1.3.3 Commissioning.................................................................................................................................... 8
1.3.4 Operation............................................................................................................................................. 9
1.3.5 Maintenance........................................................................................................................................ 9
1.3.6 Drive system: Commissioning and project planning............................................................................ 9
1.4 Use of the safety instructions................................................................................................................ 10
1.4.1 Structure of the safety instructions.................................................................................................... 10
1.4.2 Explaining signal words and safety alert symbol............................................................................... 10
1.4.3 Symbols used.................................................................................................................................... 12
1.4.4 Signal graphic explanation on the device.......................................................................................... 12
1.5 Names and abbreviations..................................................................................................................... 12
1.6 Customer feedback............................................................................................................................... 12
2 System overview.......................................................................................................... 13
2.1 Introduction........................................................................................................................................... 13
2.2 Performance of the control aystem....................................................................................................... 14
2.3 4-axis configuration - for the classical milling machine......................................................................... 16
2.4 3-axis configuration - for the classical turning machine........................................................................ 17
3 Important instructions on use....................................................................................... 19
3.1 Intended use......................................................................................................................................... 19
3.1.1 Introduction........................................................................................................................................ 19
3.1.2 Areas of use and application............................................................................................................. 19
3.2 Unintended use..................................................................................................................................... 20
4 Safety instructions for electric drives and controls....................................................... 21
4.1 Definitions of terms............................................................................................................................... 21
4.2 General information.............................................................................................................................. 22
4.2.1 Using the Safety instructions and passing them on to others............................................................ 22
4.2.2 Requirements for safe use................................................................................................................ 22
4.2.3 Hazards by improper use.................................................................................................................. 23
4.3 Instructions with regard to specific dangers.......................................................................................... 24
4.3.1 Protection against contact with electrical parts and housings........................................................... 24
4.3.2 Protective extra-low voltage as protection against electric shock .................................................... 25
4.3.3 Protection against dangerous movements........................................................................................ 26
4.3.4 Protection against electromagnetic and magnetic fields during operation and mounting.................. 27
4.3.5 Protection against contact with hot parts........................................................................................... 28
4.3.6 Protection during handling and mounting.......................................................................................... 28
DOK-MTXMIC-EASY*******-CO06-EN-P Bosch Rexroth AG I/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
Table of Contents